Ductwork

Nordfab Angle Flanges are industry standard sizes and hole patterns. Quick-Fit ducting components are adaptable to your existing ductwork. Quick-Fit has been used in a wide variety of applications, wherever dust collection or fine particulate transfer...

Tested by MET Laboratories to hold, without failure, up to 170lbs for 9” ducting and up to 850lbs for 20” ducting. For strut channel mounting (strut not included). Nut and bolt included.

Tested by MET Laboratories to hold, without failure, up to 170lbs for 9” ducting and up to 850lbs for 20” ducting. For strut channel mounting (strut not included). Nut and bolt included.

Nordfab’s QF® Angle Flange Adapter is fitted with an industry standard Angle Flange on one end and a Quick-Fit (QF) rolled edge at the other, allowing quick connection of QF duct pipe or fittings to flanged pipes or fittings. If a custom hole...

12 Gauge End Plates are used to cap-off an unused ducting port. They are ideal for future expansion or when a machine has been moved. End Plates are designed for use with flanged ductwork. Available in Galvanized Available in diameters up to 72"...

12 Gauge End Plates are used to cap-off an unused ducting port. They are ideal for future expansion or when a machine has been moved. End Plates are designed for use with flanged ductwork. Available in Galvanized Available in diameters up to 72"...

Nordfab Angle Flanges are industry standard sizes and hole patterns. Quick-Fit ducting components are adaptable to your existing ductwork. Quick-Fit has been used in a wide variety of applications, wherever dust collection or fine particulate transfer...

3”-24” made from galvanized steel 14 GA, SS is 16 GA. Over 24 inches made from 3/16” flat bar steel. Supplied with two halves bolted together.

3”-24” made from galvanized steel 14 GA, SS is 16 GA. Over 24 inches made from 3/16” flat bar steel. Supplied with two halves bolted together.

Nordfab QF® In-cut duct fittings are used to cut into existing duct lines to begin a Quick-Fit (QF) section in the system. QF In-cuts are standard 30° or optional 45°. In-cuts are also known as “saddle taps”. Specify A and C...

Nordfab QF® In-cut duct fittings are used to cut into existing duct lines to begin a Quick-Fit (QF) section in the system. QF In-cuts are standard 30° or optional 45°. In-cuts are also known as “saddle taps”. Specify A and C...

Nordfab QF® In-cut duct fittings are used to cut into existing duct lines to begin a Quick-Fit (QF) section in the system. QF In-cuts are standard 30° or optional 45°. In-cuts are also known as “saddle taps”. Specify A and C...