Ductwork

Flanged Branches (sometimes called “wyes” or “laterals”) are standard with Angle Flanges on both ends, the flanges are retained via a vanstone lip so that bolt holes can easily be aligned with those on existing flanged connections...

3”-24” made from galvanized steel 14 GA, SS is 16 GA. Over 24 inches made from 3/16” flat bar steel. Supplied with two halves bolted together.

Nordfab flanged elbows are standard with Angle Flanges on both ends. The flange is retained via a vanstone lip so that bolt holes can easily be aligned with those on existing flanged connections. Nordfab’s Flanged Long Radius elbows are available...

Nordfab flanged elbows are standard with Angle Flanges on both ends. The flange is retained via a vanstone lip so that bolt holes can easily be aligned with those on existing flanged connections. Nordfab’s Flanged Long Radius elbows are available...

Nordfab Reducers provide easy transition from one size of duct pipe or fitting to a smaller size. When ordering reducers, specify dimensions of both A and B ends. Rotational Angle Flanges retained vanstone lip is standard. If welded flanges required,...

Nordfab Reducers provide easy transition from one size of duct pipe or fitting to a smaller size. When ordering reducers, specify dimensions of both A and B ends. Rotational Angle Flanges retained vanstone lip is standard. If welded flanges required,...

Dimensionally, Nordfab QF® Router Hoods are very similar to surface grinder hoods and are often used as a replacement, with a standard 6″ x 12″ opening. These hoods are also available with a magnet. Available in Galvanized and 304SS or...

Used to adjust airflow to balance system by introducing ambient air. Available in Galvanized and 304SS or optional 316SS or carbon steel Available with flanged ends in diameters up to 24", and other various end types Optional gauges 20, 18 and...

Used to adjust airflow to balance system by introducing ambient air. Available in Galvanized and 304SS or optional 316SS or carbon steel Available with flanged ends in diameters up to 24", and other various end types Optional gauges 20, 18 and...

Allows access without removal of pipe. Product length equals nominal pipe length, and cannot be made shorter than 36". 6”-24” units have a 7” x 14” access hole. Available in Galvanized and 304SS or optional 316SS or...

Nordfab Flanged T-branch duct fittings are available in galvanized and stainless steel. When ordering tees, specify A, C. All branches priced by large end. The two “A” ends must be the same dimension, however “B” must be equal to...

Ducting elbows, sometimes referred to as bends, allow airflow direction change in a straight run of ductwork. Nordfab’s QF® Long Radius elbows are available in 90°, 60°, 45°, and 30°, in galvanized or stainless steel, (specify...