Ductwork

Nordfab’s 14Ga Angle Flange Adapter is fitted with an industry standard Angle Flange on one end and a Quick-Fit® (QF) rolled edge at the other, allowing quick connection of QF duct pipe or fittings to flanged pipes or fittings. If a custom...

Allows access without removal of pipe. Product length equals nominal pipe length, and cannot be made shorter than 36". 6”-24” units have a 7” x 14” access hole. Available in Galvanized and 304SS or optional 316SS or...

Nordfab Reducers provide easy transition from one size of duct pipe or fitting to a smaller size. When ordering reducers, specify dimensions of both A and B ends. Rotational Angle Flanges retained vanstone lip is standard. If welded flanges required,...

Nordfab Reducers provide easy transition from one size of duct pipe or fitting to a smaller size. When ordering reducers, specify dimensions of both A and B ends. Rotational Angle Flanges retained vanstone lip is standard. If welded flanges required,...

Dimensionally, Nordfab QF® Router Hoods are very similar to surface grinder hoods and are often used as a replacement, with a standard 6″ x 12″ opening. These hoods are also available with a magnet. Available in Galvanized and 304SS or...

Nordfab flanged elbows are standard with Angle Flanges on both ends. The flange is retained via a vanstone lip so that bolt holes can easily be aligned with those on existing flanged connections. Nordfab’s Flanged Long Radius elbows are available...

Nordfab Flanged T-branch duct fittings are available in galvanized and stainless steel. When ordering tees, specify A, C. All branches priced by large end. The two “A” ends must be the same dimension, however “B” must be equal to...

Nordfab Reducers provide easy transition from one size of duct pipe or fitting to a smaller size. When ordering reducers, specify dimensions of both A and B ends. Rotational Angle Flanges retained vanstone lip is standard. If welded flanges required,...

Nordfab Reducers provide easy transition from one size of duct pipe or fitting to a smaller size. When ordering reducers, specify dimensions of both A and B ends. Rotational Angle Flanges retained vanstone lip is standard. If welded flanges required,...

Tested by MET Laboratories to hold, without failure, up to 170lbs for 9” and up to 850lbs for 20″. Cannot be used as a Clamp connection. Clearance hole 7/16".

Tested by MET Laboratories to hold, without failure, up to 170lbs for 9” and up to 850lbs for 20″. Cannot be used as a Clamp connection. Clearance hole 7/16".

Flanged Branches (sometimes called “wyes” or “laterals”) are standard with Angle Flanges on both ends, the flanges are retained via a vanstone lip so that bolt holes can easily be aligned with those on existing flanged connections...