Ductwork

Nordfab Angle Flanges are industry standard sizes and hole patterns. Quick-Fit ducting components are adaptable to your existing ductwork. Quick-Fit has been used in a wide variety of applications, wherever dust collection or fine particulate transfer...

Nordfab’s 14Ga Angle Flange Adapter is fitted with an industry standard Angle Flange on one end and a Quick-Fit® (QF) rolled edge at the other, allowing quick connection of QF duct pipe or fittings to flanged pipes or fittings. If a custom...

Nordfab’s 14Ga Angle Flange Adapter is fitted with an industry standard Angle Flange on one end and a Quick-Fit® (QF) rolled edge at the other, allowing quick connection of QF duct pipe or fittings to flanged pipes or fittings. If a custom...

Tested by MET Laboratories to hold, without failure, up to 170lbs for 9” and up to 850lbs for 20″. Cannot be used as a Clamp connection. Clearance hole 7/16".

Tested by MET Laboratories to hold, without failure, up to 170lbs for 9” and up to 850lbs for 20″. Cannot be used as a Clamp connection. Clearance hole 7/16".

Ducting elbows, sometimes referred to as bends, allow airflow direction change in a straight run of ductwork. Nordfab’s QF® Long Radius elbows are available in 90°, 60°, 45°, and 30°, in galvanized or stainless steel, (specify...

Ducting elbows, sometimes referred to as bends, allow airflow direction change in a straight run of ductwork. Nordfab’s QF® Long Radius elbows are available in 90°, 60°, 45°, and 30°, in galvanized or stainless steel, (specify...

Provides weather protection for roof penetration. Bolted at seam. 23° slope maximum. Available in Galvanized and 304SS (as shown below) or optional 316SS or carbon steel Contact us for assistance with material / custom options.

Flanged Branches (sometimes called “wyes” or “laterals”) are standard with Angle Flanges on both ends, the flanges are retained via a vanstone lip so that bolt holes can easily be aligned with those on existing flanged connections...

Flanged Branches (sometimes called “wyes” or “laterals”) are standard with Angle Flanges on both ends, the flanges are retained via a vanstone lip so that bolt holes can easily be aligned with those on existing flanged connections...

Flanged Branches (sometimes called “wyes” or “laterals”) are standard with Angle Flanges on both ends, the flanges are retained via a vanstone lip so that bolt holes can easily be aligned with those on existing flanged connections...

Flanged Branches (sometimes called “wyes” or “laterals”) are standard with Angle Flanges on both ends, the flanges are retained via a vanstone lip so that bolt holes can easily be aligned with those on existing flanged connections...