Ductwork

The Nordfab 18 gauge Quick-Fit® Sleeve, formerly known as the Adjustable Nipple, is used to quickly provide variable length adjustments in ducting lines of QF Pipe. QF Sleeve seams are laser welded, preventing leakage. Quick-Fit ducting components...

The Nordfab 18 gauge Quick-Fit® Sleeve, formerly known as the Adjustable Nipple, is used to quickly provide variable length adjustments in ducting lines of QF Pipe. QF Sleeve seams are laser welded, preventing leakage. Quick-Fit ducting components...

Ducting elbows, sometimes referred to as bends, allow airflow direction change in a straight run of ductwork. Nordfab’s QF® Long Radius elbows are available in 90°, 60°, 45°, and 30°, in galvanized or stainless steel, (specify...

Nordfab 16 gauge Flanged Duct Pipe is for applications requiring pipe in sizes greater than 24″ diameter or pipe with flanged connections. The rotational Angle Flange is retained by a Van Stone lip on the pipe end. Flange fully welded upon request...

Nordfab’s QF® Angle Flange Adapter is fitted with an industry standard Angle Flange on one end and a Quick-Fit (QF) rolled edge at the other, allowing quick connection of QF duct pipe or fittings to flanged pipes or fittings. If a custom hole...

3”-24” made from galvanized steel 14 GA, SS is 16 GA. Clearance hole 7/16”. Supplied with two halves bolted together.

3”-24” made from galvanized steel 14 GA, SS is 16 GA. Clearance hole 7/16”. Supplied with two halves bolted together.

Nordfab Reducers provide easy transition from one size of duct pipe or fitting to a smaller size. When ordering reducers, specify dimensions of both A and B ends. Rotational Angle Flanges retained vanstone lip is standard. If welded flanges required,...

Nordfab Reducers provide easy transition from one size of duct pipe or fitting to a smaller size. When ordering reducers, specify dimensions of both A and B ends. Rotational Angle Flanges retained vanstone lip is standard. If welded flanges required,...

Tested by MET Laboratories to hold, without failure, up to 170lbs for 9” ducting and up to 850lbs for 20” ducting. For strut channel mounting (strut not included). Nut and bolt included.

Tested by MET Laboratories to hold, without failure, up to 170lbs for 9” ducting and up to 850lbs for 20” ducting. For strut channel mounting (strut not included). Nut and bolt included.

QF® Elbows in 16 gauge are constructed of gores lapped over one another and spot welded. This is a directional elbow and supplied with an arrow to indicate the direction of flow. Please specify direction if ordering ends other than QF. Other CLRs...