Ductwork

Nordfab 14 gauge Flanged Duct Pipe is for applications requiring pipe in sizes greater than 24″ diameter or pipe with flanged connections. The rotational Angle Flange is retained by a Van Stone lip on the pipe end. Flange fully welded upon request...

For use with Nordfab Angle Flanges or Angle Flange Adapters. Gasket dimensions match Angle Flange dimensions. Red silicone material optimal for higher temperature applications. Silicone temperature range -65° to 450°. One gasket should be used...

Provides weather protection for roof penetration. Bolted at seam. 23° slope maximum. Available in Galvanized and 304SS (as shown below) or optional 316SS or carbon steel Contact us for assistance with material / custom options.

Nordfab 18 gauge Flanged Duct Pipe is for applications requiring pipe in sizes greater than 24″ diameter or pipe with flanged connections. The rotational Angle Flange is retained by a Van Stone lip on the pipe end. Flange fully welded upon request...

Nordfab’s QF® Angle Flange Adapter is fitted with an industry standard Angle Flange on one end and a Quick-Fit (QF) rolled edge at the other, allowing quick connection of QF duct pipe or fittings to flanged pipes or fittings. If a custom hole...

Tested by MET Laboratories to hold, without failure, up to 170lbs for 9” and up to 850lbs for 20″. Cannot be used as a Clamp connection. Clearance hole 7/16".

Tested by MET Laboratories to hold, without failure, up to 170lbs for 9” and up to 850lbs for 20″. Cannot be used as a Clamp connection. Clearance hole 7/16".

The Nordfab 18 gauge Quick-Fit® Sleeve, formerly known as the Adjustable Nipple, is used to quickly provide variable length adjustments in ducting lines of QF Pipe. QF Sleeve seams are laser welded, preventing leakage. Quick-Fit ducting components...

The Nordfab 18 gauge Quick-Fit® Sleeve, formerly known as the Adjustable Nipple, is used to quickly provide variable length adjustments in ducting lines of QF Pipe. QF Sleeve seams are laser welded, preventing leakage. Quick-Fit ducting components...

Nordfab In-cut duct fittings are used to cut into existing lines of industrial ductwork. In-cuts are standard 30° or optional 45°. In-cuts are also known as “saddle taps”. Specify A and C diameter and end treatment. Priced by C...

Nordfab Flanged Tap-In duct fittings are used to cut into existing lines of industrial ducting. Specify A (existing pipe diameter) and C diameter and end treatment. Priced by C diameter. Rotational Angle Flanges retained vanstone lip is standard. If...

Nordfab In-cut duct fittings are used to cut into existing lines of industrial ductwork. In-cuts are standard 30° or optional 45°. In-cuts are also known as “saddle taps”. Specify A and C diameter and end treatment. Priced by C...