Ductwork

Nordfab QF® Tap-In duct fittings are used to cut into existing lines to begin a Quick-Fit (QF) system. Specify A (existing pipe diameter) and C diameter and end treatment. Standard end is QF. Priced by C diameter. Saddle length and width = 3"...

Nordfab flanged elbows are standard with Angle Flanges on both ends. The flange is retained via a vanstone lip so that bolt holes can easily be aligned with those on existing flanged connections. Also available in Long Radius. Available in Galvanized...

Nordfab flanged elbows are standard with Angle Flanges on both ends. The flange is retained via a vanstone lip so that bolt holes can easily be aligned with those on existing flanged connections. Also available in Long Radius. Available in Galvanized...

Tested by MET Laboratories to hold, without failure, up to 170lbs for 9” and up to 850lbs for 20″. Cannot be used as a Clamp connection. Clearance hole 7/16".

Tested by MET Laboratories to hold, without failure, up to 170lbs for 9” and up to 850lbs for 20″. Cannot be used as a Clamp connection. Clearance hole 7/16".

For use with Nordfab Angle Flanges or Angle Flange Adapters. Gasket dimensions match Angle Flange dimensions. Standard gasket is constructed of black nitrile, 60 durometer, a conductive material. Red silicone material optional for higher temperature...

Nordfab 18 gauge Flanged Duct Pipe is for applications requiring pipe in sizes greater than 24″ diameter or pipe with flanged connections. The rotational Angle Flange is retained by a Van Stone lip on the pipe end. Flange fully welded upon request...

The Nordfab 18 gauge Quick-Fit® Sleeve, formerly known as the Adjustable Nipple, is used to quickly provide variable length adjustments in ducting lines of QF Pipe. QF Sleeve seams are laser welded, preventing leakage. Quick-Fit ducting components...

The Nordfab 18 gauge Quick-Fit® Sleeve, formerly known as the Adjustable Nipple, is used to quickly provide variable length adjustments in ducting lines of QF Pipe. QF Sleeve seams are laser welded, preventing leakage. Quick-Fit ducting components...

Nordfab flanged duct pipe is for applications requiring pipe sizes greater than 24″ diameter or where flanged connections are required. The rotational Angle Flanges on our Flanged Pipes are retained by Van Stone lips on the pipe ends. Angle...

Provides weather protection (outdoors) and cover (indoors) for wall penetration. Ordering one QF® Wall Flashing provides you with both 1 inside and 1 outside flashing (4 halves). Available in Galvanized and 304SS (as shown below) or optional 316SS...

Provides cover for roof penetration. Made in two halves and caulked. 23° roof slope maximum. Available in Galvanized and 304SS (as shown below) or optional 316SS or carbon steel Contact us for assistance with material / custom options.