Ductwork

Nordfab Angle Flanges are industry standard sizes and hole patterns. Quick-Fit ducting components are adaptable to your existing ductwork. Quick-Fit has been used in a wide variety of applications, wherever dust collection or fine particulate transfer...

Nordfab's Quick-Fit® Clamp with Silicone Seal provides quick and easy connections for Nordfab’s Quick-Fit Duct ductwork. Quick-Fit Ducting is ideal for dust collection and process ventilation systems, saving time and money on installation,...

Nordfab's Quick-Fit® Clamp provides quick and easy connections for Nordfab’s Quick-Fit Duct ductwork. Quick-Fit Ducting is ideal for dust collection and process ventilation systems, saving time and money on installation, future relocations,...

Nordfab's Quick-Fit® Clamp provides quick and easy connections for Nordfab’s Quick-Fit Duct ductwork. Quick-Fit Ducting is ideal for dust collection and process ventilation systems, saving time and money on installation, future relocations,...

For use with Nordfab Angle Flanges or Angle Flange Adapters. Gasket dimensions match Angle Flange dimensions. Standard gasket is constructed of black nitrile, 60 durometer, a conductive material. Red silicone material optional for higher temperature...

New Improved Design: Easier to install No adhesive needed, fits snugly around rolled edge Non-directional Fewer sizes required Same conductive material (no material change from previous design) General purpose oil resistant polymer. Performs well...

Nordfab's Quick-Fit® Clamp with Silicone Seal provides quick and easy connections for Nordfab’s Quick-Fit Duct ductwork. Quick-Fit Ducting is ideal for dust collection and process ventilation systems, saving time and money on installation,...

3”-24” made from galvanized steel 14 GA, SS is 16 GA. Over 24 inches made from 3/16” flat bar steel. Supplied with two halves bolted together.

Nordfab Angle Flanges are industry standard sizes and hole patterns. Quick-Fit ducting components are adaptable to your existing ductwork. Quick-Fit has been used in a wide variety of applications, wherever dust collection or fine particulate transfer...

Tested by MET Laboratories to hold, without failure, up to 170lbs for 9” ducting and up to 850lbs for 20” ducting. For strut channel mounting (strut not included). Nut and bolt included.

Tested by MET Laboratories to hold, without failure, up to 170lbs for 9” ducting and up to 850lbs for 20” ducting. For strut channel mounting (strut not included). Nut and bolt included.

QF® End Caps connect easily with the QF clamp and are used to cap-off an unused ducting port. They are ideal for future expansion or when a machine has been moved. Available in Galvanized and 304SS (as shown below) or optional 316SS or carbon steel...