Ductwork

Nordfab’s 14Ga Angle Flange Adapter is fitted with an industry standard Angle Flange on one end and a Quick-Fit® (QF) rolled edge at the other, allowing quick connection of QF duct pipe or fittings to flanged pipes or fittings. If a custom...

Nordfab 16 gauge Flanged Duct Pipe is for applications requiring pipe in sizes greater than 24″ diameter or pipe with flanged connections. The rotational Angle Flange is retained by a Van Stone lip on the pipe end. Flange fully welded upon request...

Provides weather protection (outdoors) and cover (indoors) for wall penetration. Ordering one QF® Wall Flashing provides you with both 1 inside and 1 outside flashing (4 halves). Available in Galvanized and 304SS (as shown below) or optional 316SS...

Provides cover for roof penetration. Made in two halves and caulked. 23° roof slope maximum. Available in Galvanized and 304SS (as shown below) or optional 316SS or carbon steel Contact us for assistance with material / custom options.

Nordfab flanged duct pipe is for applications requiring pipe sizes greater than 24″ diameter or where flanged connections are required. The rotational Angle Flanges on our Flanged Pipes are retained by Van Stone lips on the pipe ends. Angle...

Nordfab flanged duct pipe is for applications requiring pipe sizes greater than 24″ diameter or where flanged connections are required. The rotational Angle Flanges on our Flanged Pipes are retained by Van Stone lips on the pipe ends. Angle...

When ordering tees, specify A, C. All branches priced by large end. “A1” to “A2” must be the same dimension, however “C” must be equal to or smaller than the “A” dimensions. Use the following formula to...

When ordering tees, specify A, C. All branches priced by large end. “A1” to “A2” must be the same dimension, however “C” must be equal to or smaller than the “A” dimensions. Use the following formula to...

When ordering tees, specify A, C. All branches priced by large end. “A1” to “A2” must be the same dimension, however “C” must be equal to or smaller than the “A” dimensions. Use the following formula to...

Reduces vibration from the fan to the ducting system. Available in Galvanized and 304SS or optional 316SS or carbon steel Available with flanged ends in diameters up to 24", and other various end types Optional 16 gauge Contact us for...

Nordfab’s 14Ga Angle Flange Adapter is fitted with an industry standard Angle Flange on one end and a Quick-Fit® (QF) rolled edge at the other, allowing quick connection of QF duct pipe or fittings to flanged pipes or fittings. If a custom...

QF® Elbows in 16 gauge are constructed of gores lapped over one another and spot welded. This is a directional elbow and supplied with an arrow to indicate the direction of flow. Please specify direction if ordering ends other than QF. Other CLRs...