Ductwork

Nordfab's Quick-Fit® Clamp provides quick and easy connections for Nordfab’s Quick-Fit Duct ductwork. Quick-Fit Ducting is ideal for dust collection and process ventilation systems, saving time and money on installation, future relocations,...

3”-24” made from galvanized steel 14 GA, SS is 16 GA. Clearance hole 7/16”. Supplied with two halves bolted together.

3”-24” made from galvanized steel 14 GA, SS is 16 GA. Clearance hole 7/16”. Supplied with two halves bolted together.

For use with Nordfab Angle Flanges or Angle Flange Adapters. Gasket dimensions match Angle Flange dimensions. Standard gasket is constructed of black nitrile, 60 durometer, a conductive material. Red silicone material optional for higher temperature...

New Improved Design: Easier to install No adhesive needed, fits snugly around rolled edge Non-directional Fewer sizes required Same conductive material (no material change from previous design) General purpose oil resistant polymer. Performs well...

Nordfab's Quick-Fit® Clamp with ePTFE Seal provides quick and easy connections for Nordfab’s Quick-Fit Duct ductwork. Quick-Fit Ducting is ideal for dust collection and process ventilation systems, saving time and money on installation,...

3”-24” made from galvanized steel 14 GA, SS is 16 GA. Over 24 inches made from 3/16” flat bar steel. Supplied with two halves bolted together.

Nordfab Angle Flanges are industry standard sizes and hole patterns. Quick-Fit ducting components are adaptable to your existing ductwork. Quick-Fit has been used in a wide variety of applications, wherever dust collection or fine particulate transfer...

QF® End Caps connect easily with the QF clamp and are used to cap-off an unused ducting port. They are ideal for future expansion or when a machine has been moved. Available in Galvanized and 304SS (as shown below) or optional 316SS or carbon steel...

Nordfab QF® Machine Adapters allow easy connection of Quick-Fit (QF) ductwork to machines requiring dust or fume removal. Ends are QF (rolled edge) to NOFIT (plain edge). If expanded, specify desired ID or OD of NOFIT end. Expanded must be within...

Nordfab QF® Machine Adapters allow easy connection of Quick-Fit (QF) ductwork to machines requiring dust or fume removal. Ends are QF (rolled edge) to NOFIT (plain edge). If expanded, specify desired ID or OD of NOFIT end. Expanded must be within...

14 Gauge End Plates are used to cap-off an unused ducting port. They are ideal for future expansion or when a machine has been moved. End Plates are designed for use with flanged ductwork. For ductwork with QF ends, 14 Gauge End Caps are available...